I saw this on another forum and figured I'd document the steps of the loading process. This is a general technique I was taught by a few fellas on here, I did not create these recipes or process and I am simply documenting the process I was shown as well as the tools used to help anyone in future. I'd like to thank Hawglips, Basser69, 3Toe, and Squeaky for their instruction and helping me with all my questions.

Firstly you need shell components and shot each recipe will call for slightly different components so I will not get into component or load specifics. I ordered most components And tools from BPI or precision reloading.
[Linked Image]

Also, you will need a few tools. All of which will cost about 100$
ReLoading scale
Hull vice
Roll crimp die
Drill (preferably a drill press)
Powder trickler
Buffer dipper/scoop
Shell holder (this I made from a 1x6 and drilled 10 holes to fit a 20ga hull)
5/8" dowel cut to 2-3/8" length with screw in one end
[Linked Image]

Originally Posted By: Wiley Coyote
Well, the way I see it is there's just too many assholes
On a good day there's a bunch of assholes in here. On a bad day there's too many assholes in here.