Originally Posted By: DEADorALIVE
Originally Posted By: GomerPyle
I'd read that about the bent shaft, but it seems like if the shaft was bent enough to make it hard to turn, it'd be hard to turn either direction (and it's only hard to turn to the right), and it also seems it would be difficult to turn all the time, not just when it's under power....if I'm sitting still and the prop isn't spinning, it spins freely side-to-side. I'll check the shaft though to see if there is a visible bend.

When yours was bent, was it difficult to turn either direction and regardless of whether you were under power or not?


Mine turned freely until it got about 30° off to either side, then it would bind. Once I got to looking at it closer, the bend in mine was obvious, but I was told that that might not always be the case.


Hmm....mine doesn't bind at all as long as the prop isn't spinning...I dunno

There are 3 certainties in an uncertain world:

1. All Politicians Are Liars
2. All Gun Laws Are an Infringement
3. Taxation Is Theft