|
|
|
|
1
|
2
|
3
|
4
|
|
5
|
6
|
7
|
8
|
9
|
10
|
11
|
|
12
|
13
|
14
|
15
|
16
|
17
|
18
|
|
19
|
20
|
21
|
22
|
23
|
24
|
25
|
|
26
|
27
|
28
|
29
|
30
|
31
|
|
|
|
110 registered members (BhamFred, alhawk, hunter84, Buckwheat, bamaeyedoc, SouthBamaSlayer, hopper35005, Bigem1958, Gut Pile 32, Skillet, lectrode, 4Tigers, BPI, Treelimb, Gizmo76, Raven, Fishbones, USeeMSpurs, Huntn2feed5, MC21, Mike0360, roll_tide_hunts, MGrubber, Dubie, MarksOutdoors, mayberry51, BradB, jaredhunts, Scout308, georgiaboy1970, DGAMBLER, Holcomb, Young20, GomerPyle, Epalm88, Kicker, GrandSlam, turkey247, Hunter454, BC, 7PTSPREAD, Shotts, G/H, johnv, crenshawco, cartervj, CCC, Dragfan66, Beer Belly, Skullworks, Hoytdad10, Ar-Humter, Bowfish, Morris, Tree Dweller, BayedUp, woodduck, oldbowhunter, CrappieMan, KnightRyder, M48scout, Shmoe, mdavis, Joe4majors, mcninja, Chancetribe, timberwolfe, Red Fox, CKyleC, Peach, lefthorn, sj22, WEMOhunter, Turkey, Showout, jwalker77, oldforester, CrimsonWSM, Exhoosier, Driveby, desertdog, olemossy, OutdoorsAL, BACK40, Calvin, doublefistful, HBWALKER14, JonBoy85, bamabeagler, BearBranch, JHL, Jwillbucks, PourIron12, rkt, Southal, CeeHawk37, Fedex 1, Muzzy76, akbejeepin, BamaBoHunter, wk2hnt, 9 invisible),
1,199
guests, and 0
spiders. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
Re: Bush hog-help an amateur out
[Re: Hogwild]
#1435777
09/01/15 03:51 AM
09/01/15 03:51 AM
|
Joined: Nov 2009
Posts: 2,538
Birmingham, Al
akbejeepin
OP
10 point
|
OP
10 point
Joined: Nov 2009
Posts: 2,538
Birmingham, Al
|
It is missing a Grade 8 bolt, nut, washers along with spacer sleeve in the bottom hole. That bolt/spacre setup is slightly longer than the top to allow the connection to be tight and secure while still allowing the top joint to swivel.
Other than that, it is correct.
The lift arms will rise to allow the mower to come up any higher if needed when going through a dip and the small amount of swivel in the top link allows the rear of the mower to float over slightly uneven ground. That makes sense. If it were to set it up that way, the linkage would have a good bit more pivot if it was needed. I will figure out what all size hardware I need this week. Thanks guys.
|
|
|
|
