Any of you ever built a boomless sprayer? I have an old 3-point boom sprayer I want to convert to boomless. Chime in about pumps and nozzles if you’ve done it. Thanks!

pto pumps or 12v pumps?

Wide swath nozzle, needs a 2 GPM pump or bigger. will cover 40ft
https://www.stevenstractor.com/home...q2faM5AIVh56zCh2drgvSEAQYCSABEgKRdPD_BwE

16 ft swath nozzle for 2 or higher gpm pump.
https://www.amazon.com/Valley-Indus...&hvtargid=pla-318198543106&psc=1

if you want smaller spray pattern id get rain bird nozzles for under $5 each

The pto pump that’s currently on it is like this, but it’s locked up. I basically have the 3-point mounted tank to work with. Everything else is trashed.

https://www.tractorsupply.com/tsc/product/hypro-6-roller-cast-iron-sprayer-pump?cm_vc=-10005

Check Northern Tool's website. They have a good selection of quality parts.

Start by looking at a brass Teejet boomless head and six roller pump.

I soaked my roller pump in transmission fluid to unlock it. Get as much inside through the inlet and discharge ports as you can and let it sit over night. If that don't work, take it apart. Ya got nothing to lose.

Soak the pump in pb blaster. It should unstick.

I converted my 3pt to boomless. I went with three "6541-1 Boomless flat spray nozzle 1/2" #10" (from Amazon https://www.amazon.com/6541-1-Booml...;qid=1566240258&s=gateway&sr=8-3
). They just thread onto a piece of 1/2" pipe with some teflon tape. I did three, middle one is for fields and wide areas, the outside ones are mounted sorta vertically and I use them to spray the sides of roads and fields.

Mine works great. I also bought some electronic valves and wired it up so I can turn them on and off from inside the cab. I was tired of getting in and out to turn valves on or raise and lower the booms.

I have a 6 roller PTO pump. Flush it out really good AFTER EACH USE, especially after using herbicdes. And I take the pump off and put somewhere with no chance of freezing in the winter, I keep mine in the camp house laundry room.