This was purchased NIB directly from MDWS...it's shooting groups of...(at 100 yards):

.1689" w/85g Barnes MPG #30249.
.2646" w/90g Sierra #1800.
.1820" w/95g MDWS Makers.

(ILL SEND ALL THREE FORMULAS WITH PACKAGE!)


COMPLETE UPPER (***THIS IS JUST THE UPPER, I CAN INCLUDE A PSA STEALTH LOWER FOR ADDITIONAL $200)
*20" MDWS barrel, Tungsten Cerakote 11 twist.
*15" Keymod hand guard.
*Receiver marked with a "square" for identity.
*BCG w/charging handle.
*Mid length gas block/tube.


DIES/BRASS:
*277 Hornady Die set (mildly used)
*277 brass...+/-150...wet tumbled/prepped for loading (load-n-shoot ready)
*20 rounds of factory (Druid Hill) 90g Speer Gold Dot


BULLETS:
Varmint:
(1)...MDWS 95g Maker...19 ct
(2)...Sierra 90g HPFB #1800...63 ct
(3)... Barnes 85g MPG #30249...18 ct

Deer:
(4)...Barnes 85g TSX #30254...NIB 50 ct
(5)...Barnes 98g TTSX #27751...NIB 50 ct
(6)...Hornady 110g V-Max #22721...NIB 200 ct


ALL-IN-ONE PRICE...$850.00

A TURNKEY SHOOTER IF YOU FOLLOW THE RELOADING RECIPES...

THEN JUST DO YOUR PART WHEN SHOOTING...

THIS BARREL WILL DO THE REST!!


Cash, PayPal F&F (Or add $25.50 to cover 3% fee...$875.50), if you buy the lower we’ll have to meet or I’ll have to ship to FFL


Thanks for looking fellows...you can always contact me with questions, comments, or whatever

GLWS.....that’s a very good WLV startup package for someone. Do you have a round count on the bbl? Mfg of the hand guard/rail?

For now, I’m sticking with my SPC on my ARs, but I hope to be building a WLV on a CZ527 bolt gun before too long. LMK if you split things up.....I’ll be needing dies, can always use bullets, and maybe some pre-prepped brass before long.

Very nice. GLWS

I can’t remember exactly what the hand guard is. I can promise you it’s not junk and I’m known to use a lot of Foxtrot Mike’s and Strike Industries stuff.

I’ll also entertain trades and if you ask me for what, the answer is truly I don’t know. Usually something peaks my interest.

Oooooh very nice. Must....................resist...................don't do it...............look away! look away!!

I went through the spreadsheet last night to get an accurate round count on the barrel. Best I can figure, to include the proper break in procedure, is just shy of 900 rounds. This puppy is just now getting warmed up. I really don’t want to sell it but I want to build a few others so I’m using this cash to finish a couple of upper builds I’ve been dragging on for a while.

I have this listed on MeWe too.

I told a guy there that I would sell the whole package (with the lower) for $1000.

Buyer splits the 3% with me.

Freestatehunter, sorry it’s not about the gun, but who did your gator tanning?

The best in the business, John Walker Taxidermy in Deland, Florida. I’ve been lucky enough to work with a nuisance hunter in the past so I’ve killed my fair share of alligators. Every single one that I’ve wanted to keep I sent to John and he’s never let me down.

I’ll look him up. I need one done.