|
|
|
|
|
|
1
|
2
|
3
|
4
|
5
|
6
|
7
|
8
|
9
|
10
|
11
|
12
|
13
|
14
|
15
|
16
|
17
|
18
|
19
|
20
|
21
|
22
|
23
|
24
|
25
|
26
|
27
|
28
|
29
|
30
|
|
|
|
|
|
|
|
|
|
Iso
by AustinC. 05/21/24 05:01 PM
|
|
|
|
10 registered members (murf205, Big Al, Canterberry, Richard Cranium, CreekCrosser, OutdoorsAL, jbatey1, booner, BC_Reb, MDBeach7),
511
guests, and 0
spiders. |
Key:
Admin,
Global Mod,
Mod
|
|
|
Resize fix
#2124522
05/28/17 01:32 PM
05/28/17 01:32 PM
|
Joined: Apr 2013
Posts: 4,329 Northeast Florida
BamaGrad85
OP
10 point
|
OP
10 point
Joined: Apr 2013
Posts: 4,329
Northeast Florida
|
I was resizing brass earlier and as I was pulling a shell the resizer came apart. I was using resize lube so I was a bit surprised that it happened. I got the part stuck in the brass out at the expense of using a dremel grinder on the brass to get it free. I think I know how to put resizer together but not sure if it will hold. Does any one know what I need to do next or just buy a new die set?
I came, I saw, so I killed them all......Vern
|
|
|
Re: Resize fix
[Re: odocoileus]
#2128566
06/02/17 04:18 PM
06/02/17 04:18 PM
|
Joined: Apr 2013
Posts: 4,329 Northeast Florida
BamaGrad85
OP
10 point
|
OP
10 point
Joined: Apr 2013
Posts: 4,329
Northeast Florida
|
I assume it is one of the collet dies. If I understand correctly, the case is out but the sizing rod is stuck in the case? Not anymore. I used my Dremel grinder and removed the sizing rod from the case. I put it back in the collet and tightened the screw as tight as I could and finished resizing 38 more cases. It held just fine. I now have 59 cases cleaned, resized, primed and ready to load powder & bullets.
I came, I saw, so I killed them all......Vern
|
|
|
|