I just ordered me a FastFire3 and a Speed Bead mount for my SBE2. I'm trying to correct my POA/POI problems. For those of you that have these mounted on your guns, what was the best way to "Bore Sight" it, then sight it in? I know it's kinda last minute, but I won't get to hunt till Saturday.

I just looked at the bead for windage and shot dove loads for elevation.

Thanks. I was thinking about just getting it close to the bead and shooting some of winchester supreme's i have to get my elevation good. My gun shoots high right with my hevi shot choke and low with my Indian Creek.

It will be higher than the bead and for most benellis just a touch to the right of bead. I took my speed bead off bc it peeled the skin off my thumb every shot with 3.5's

Mine ended up slightly left of the bead. You can put it in a vise or on sand bags and line your beads up then attach sight and dial it in. Got mine really close this way

Like mentioned above, I would just shoot bird shot at 10 yards to get it close, then back up to 20 with birdshot, then try one of your turkey shells at 20 to see where to go from there and back it on up

Thanks guys. Hopefully it will be in before friday.

Has anyone had trouble installing on 11-87?

What kind of trouble?

If by trouble you mean being borderline running out of vertical adjustment, then yes. Otherwise, no.

A gunsmith drilled and tapped it for a 336 base for me without any reservation although some folks will tell you that the top of the receiver is too thin to drill/tap.