Thanks for all the help I tried it again today with the same results but I did figure out that something is happening when I seat the bullet because I can trim,chamfer and debur the brass and it chambers just as smooth as can be but I can take and seat a bullet and not so smooth. After reading that it may have something to do with it being a belted magnum I decided to try it with a 243. I went through all the correct steps as far as I know setting my dies up and everything and just like with the 7mm mag all was good until I seated a bullet and in my 243 I almost couldn't even get the bolt to lock down at all so I'm not sure what's going on. To answer the question about the dies I'm using they're all RCBS either new or lightly used.