Aldeer.com Forums Alabama Deer Talk Al - HandLoader Forum WHAT DID YOU DO IN THE RELOADING ROOM TODAY.

I spent the past 2 days sorting and cleaning brass, mostly .308.

I also put together some .270 loads to test in the Ruger #1 and Savage Axis....130gr partitions and H4831

Tested the loads I put together yesterday.....Ruger #1 in 270 LOVES 60gr H4831 under a 130gr Partition, Savage axis likes it, also. the 2 6.5cm Savage axis rifles I worked with today both liked 40.5 grains of H4350 under a 143gr ELD-X.

Gonna get a good supply of both loaded up tomorrow.

Finally got my 06 to like some 165 gr interlocks
Gone play with my 7-30 waters tomm and do a loading I think

Loaded up 90 of the .270's so far. Taking a lunch break and then gonna load up 100 of the 6.5 cm

Finally found a load for this predator. My first load ever. Took 36 shots to get a group I liked. Sat down and loaded a box after that.

Got a set of used 30-40 krag dies. A clean up is always the first step before using.
Into the sink with hot soapy water and a degreaser. Dried in the oven an recoiled an now ready to go.

I reload something every day. Yesterday was 40 rounds of 30-06 for my Garands, today prepped and primed 100 cases of 30 carbine. Its relaxing.

Loaded up some 338-06 test loads

Worked up about 200 pieces of 30-06 ready for the wet tumbler when USPS gets it here

Getting ready to clean up two sets of dies when they arrive. Another good deal on a set of Hornady-Pacific in 7mm magnum and 7.62x54R.

Started loading for my .308

Working through the 40 rounds of 7.5 Swiss and 90 rounds of 5.56 I fired on Tuesday.

Wet tumbled bout 300 30-06, 75 7 mm rem mag and loaded them with a couple pet loads gone load a box of 30-06 with 165 gr interlocks over a dose of imr 4350 here shortly

My new-used dies arrived. I was able to add an additional die to the group. So the 7.62 Russian, 7mm magnum, and the additional 8x57 Mauser all went into hot soapy water and got a good scrubbing inside an out. Then dried in the oven and lightly oiled ready for their next performance.

Had a little time yesterday evening and loaded up some 130gr Barnes ttsx in.308 with H335 for my Franchi momentum.

Had some bullets that were spray molyed and I unmolyed them today it sucked won't do that again

Just bought some once fired brass from US Reloading. Most of the 223/5.56 was crimped primers. Off to sportsman's warehouse to pick up a primer pocket swager from RCBS. Did a great job right out of the box. Made short work of 200 .223/5.56 & 100 7.62x39. Deprimed an in the S/S tumbler now.

Loaded up 200 6.8SPC II. 110gr prohunters and h335

Tested the load with 2 different suppressors