First you need to prepare your wads. In this case one piece of cork and 2 pieces of felt.
[Linked Image]
I pushed these down and packed them with the screw on my dowel.
[Linked Image]

Next I rolled up a Mylar (not all loads will call for this) and placed it in the wad and worked it down snug between the felt and the wad until flush with the wad.
[Linked Image]

[Linked Image]

I was shown for this particular load to trim the hulls, not all recipes may call for this. Place the dowel into the hull with screw sticking out.(you may need to take a little sand paper to dowel so it fits in hull better) and trim Hull with razor or exacto knife.
[Linked Image]

Originally Posted by Wiley Coyote
Well, the way I see it is there's just too many assholes
On a good day there's a bunch of assholes in here.
On a bad day there's too many assholes in here.