These are assorted brass from load testing and other rifles I plan to load for in the next month.

I used the FA wet tumbler, dawn soap and lemishine with 5lbs of steel pins.

Only thing is you have to be sure there are no pins stuck in primer holes or in cases. Have one of those fishing magnets that gets everything that's remotely loose.

Showed on of my nephews (who is 5) and he thought I found pirate treasure.

Good Job

Beautiful! Now more work begins...

I don't clean brass in my comp guns if I do its with a Krazy kloth or never dull I don't want to loose the carbon in the necks, helps with neck tension and seating pressure. But a pile of shiny brass is a pretty sight.

Gotta love stainless steel pins and lemishine with brass or nickel...

Agree picked these up at range yesterday, left this much more on the ground

I like that setup birdcarver. I just was using one of those cheap fishing magnets in a ziplock but that may be better.

When I use my drum cleaner with walnut hulls and ss pins , after I run for a time I pour drum out through 1/4 inch rabbit wire into a 14'' pizza pan to separate brass ,then pour media back into drum and don't have to separate pins.