Finally got all of my components in to roll my own tss.. except the hull. If anyone happens to have and 20 ga 3 inch cheddite hulls and could spare a few it would be greatly appreciated. Everywhere online is out and I was hoping to get to try one out this season. Thank y’all

I can save my Federal TSS hulls for you if you want. Are they Cheddite hulls?

I don’t reload.

I use the recipe that calls for Fio hulls, but the 2.75" hulls work fine if I leave out the red seal. I can't tell any difference in the pattern whether I use the seal or not, but it assures that the shell could be carried around for an entire hunting season without any powder migration, so I use it.

If the recipe you want to use will fit in a 2.75" Cheddite hull, I could let you have a few to get started this year. Are you close enough to Sylacauga to drive over here?

I’m a little over 2 hours from sylacauga. I believe the 2.75 should work I just will not have to trim them. I’m assuming they are high brass

I think I have some high brass ones; I'll look when I get home. The brass length really doesn't matter, but the internal dimensions of the hull could be different.

Pm me when you can check please

I do have some high brass 2.75 Cheddite, and will give you a few if you wanna go this route. Sent a pm.

If I were you I would order some of the Fio hulls from BPI. If you are using one of Hal's recipes, he developed the Fio recipe first and it's what I have used for years. The Cheddite recipe was developed only because it became hard to get the Fio hulls. Let me know