I have a PSE Decree IC and a Hoyt Defiant 30, both of which I have paper tuned very quickly, and easily. Picked up and Elite Ritual 33 and the only way I could get a bullet hole paper tune was to move the linear tunable roller all the way to the right and the QAD rest all the way to the left. Of course when I did this I was unable to sight in at 2o yds. Read everything I could on here about this with no luck so I took it to the shop. He was able to get it paper tuned to him but I’m still getting a point left nock right and nock low tear. The best I can get it is about an inch tear to the right and half an inch high high. I get this wether I use a thumb release or hinge. I’m shooting Easton FMJ’s 300 spine 30” in length with a 100 grain point. I tried purposely torquing my bow hand but with very little results. If it were the bow I would think that the man at the shop wouldn’t have been able to paper tune it so what am I doing wrong?

I noticed on the draw board that the top cam leans where as the bottom cam has little to no lean during the draw cycle, the top of the cam leans to the left or towards the riser pretty signicantly

You gone have to shim the top cam...may get lucky and be able to do it with shins that are there otherwise your gone need a shim kit

Ok thanks

You may have to put it in a bow press and change the string twist ratio. It is very easy to do but if you haven't done it before, you need to watch an expert do it. Take it to where you bought it.