Anybody loading for 6.5 Creedmoor

If so what load data are you using

Using Nosler brass, CCI primers and the Hornady 143gn ELDX being pushed by 39.5 gns of H4350
Will shoot one ragged hole 5 shot groups from a custom build I finished in November of last year

51.3 gn Imr 4150 3 shot group in quarter at 110 yds using once fired 243 brass and necked to 6.5 creedmoor

thanks, the case holds 47.1 grains of water

39.5 gr H4350 behind the 143 ELD-X is a good place to start, but you're likely going to find better nodes up between 41-43 gr in terms of velocity, SD, and ES.

I run 41.8 gr H4350 under 143 ELD-X using Hornady brass that I anneal after each firing, using a CCI 200 primer. Under half-MOA out past 800 yards...

Already tried those areas on the load scale and it just wouldn't shoot
39.5 was the sweet spot

Interesting